Calibre 01 · automatic · 40 mm
Time, taken apart.
Scroll to open a mechanical watch, layer by layer. Every part here is real-time 3D, and the hands are set to your time.
The dial catches the light.
Brushed in rays from the centre, so the highlight swings as the watch turns. The colour deepens toward the edge, a fumé finish under clear lacquer.
- Finish
- Sunburst brass, four coats of fumé lacquer
- Indices
- Applied and polished, filled with lume
- Date
- At three o'clock, framed in steel
- Crystal
- Domed sapphire, anti-reflective inside
Tap the points on the dial.
Turn it over.
Through the sapphire caseback: the gold rotor, the bridges, the balance. Move your wrist and the rotor swings to wind the mainspring. Here, your scroll does it.
- Movement
- Automatic, hours, minutes, seconds, date
- Power reserve
- 72 hours
- Jewels
- 27
- Rotor
- 18k gold, engraved
Layer by layer.
From the crystal down to the caseback, each part sits where it would in the case, pulled apart along one axis.
Eight beats a second.
The balance wheel swings back and forth four times a second. On every swing the escapement lets the gear train move one small step: 28,800 steps an hour, and each one nudges the seconds hand.
- Frequency
- 4 Hz, 28,800 vibrations an hour
- Balance
- Gilt, with sixteen timing screws
- Regulated
- In five positions, −2 to +4 seconds a day
After dark.
The hands and indices are filled with lume. It charges in daylight and glows once the lights go out.
- Applied
- By brush, in three coats
- Glow
- Blue-green, readable through the night
Make it yours.
Two hundred and fifty, each one numbered.
Calibre 01 is made in a single edition. Every caseback is engraved with its own number, 0001 to 0250, before the watch is cased.